Please refer to : [email protected]
Let me be first TXP4 user to say that "I did it!" I
successfully soldered on
the bf2 pins to my TXP4 board rev 1.02. I tested this out by using a K6-266.
It booted reading as a 266....when I set the 4.5X multiplier, it booted up
reading 300Mhz! I couldn't get it to use the 5.0X multiplier but then again,
I have no idea how to increase the voltage to 2.3 or 2.4 volts. My manual
only says how to set the "2.0v", which I think might be 2.2v.
If anyone knows how to set the different voltages for the TXP4,
please email me! My
computer dealer made the mistake of giving me a k6-266 instead of a k62-266.
I recommend the k6-2 chip for all users who successfully soldered their board
or don't want to buy a super 7 board yet because it is rated to run on a
66Mhz bus so you are not losing any performance running it on a non super-7
board.
13 September 1998 11:36 AM
